Jump to content
Mander Organs

RobH

Members
  • Content Count

    28
  • Joined

  • Last visited

Community Reputation

0 Neutral

About RobH

  • Rank
    Member

Profile Information

  • Gender
    Male
  1. I too have been encountering problems with actions/cyphering key levels all over the place etc. These are on organs which I have looked after for many years and which have given little or no trouble in the past. However, one thing which appears to be common to them all is that they are in "well heated' buildings and that the problems seem to diminish when heating is off during the week. I'm certain that Henry Willis is right about climatic conditions being to blame. It is a real pain, hard to know the best course of action and I'm fed up with it!! My ancient Bechstein piano is also causing problems by not holding its pitch as it usually does. I suspect this is due to the same reason. RDH
  2. [ I've just been tuning an organ (large Hill rebuilt by Compton at Gt Yarmouth)) with a 32' polyphonic pipe today. Very effective, but certainly DOES repeat E for the 4 remaining lowest notes.
  3. Our priest was saying today that some Catholic Dioceses have been instructing parishes to empty holy water stoups and not to give the Host straight into the mouth or to offer the chalice. I was always told that it is not possible to catch an infection from a chalice as precious metals act as an antiseptic. Is this an old wives tale? Here in Norfolk we seem to be carrying on as usual, although there did seem to be quite a few people coughing and spluttering at Mass this morning.
  4. RobH

    Organ Wanted

    Thanks for this info. Roffensis. I don't know much about Nicholson and Lord's work, have only ever come across one of their jobs, a small one in Yorkshire. Will keep you posted. Rob.
  5. RobH

    Organ Wanted

    I hope our hosts won't mind me using this forum for shamelessly appealing for a decent redundant organ. Over the past year I have been searching for a high quality largish two manual for a fairly large church. It must be by a "good" builder and have around ten ranks on each manual, preferably with tracker action to manuals. Does anyone know of such an instrument? If so, I should be delighted to hear about it. Not one of the organs listed on the IBO redundant organ site is suitable; most of them either too small, too big or just not of the best quality.
  6. Shouldn't this topic be under "The organ and its music" rather than "Nuts and Bolts" as it appears to have become a discussion about the music of the organ rather than its construction, scaling, pipe scales etc. Forgive me for being a pedantic old B.
  7. RobH

    Going Dutch

    I am very sorry that this organ has had to go to the Netherlands as it could so easily have been rehoused here. The firm for which I work has been looking for exactly such an instrument for over a year and for a glorious building in this area. Sadly, this instrument was never listed on the BIOS Redundant Organ list which is just about the only site of its kind. I am always surprised how few organs actually come up on this list. The building in question would be perfect for an instrument of this size and the funds are waiting for the right one. So if anyone reading this knows of a quality organ similar to this Harrison (Tracker action) for disposal please let it be known. I hope Mr Mander will forgive me if I appear to be "advertising", but it's really annoying to lose such a decent instrument.
  8. There is (or was) a wonderful "Bass Cornet 32" on the Compton/Wood rebuild at Wakefield Cathedral. Although it is over thirty years since I heard it, my recollection is of an impressive 'realistic' 32 foot reed. I presume this synthetic reed was quite a usual feature of larger Comptons of the period.
  9. I agree that it would be better if pipework was not touched. That is fine if you are happy for an instrument to be not finely in tune in the flue department. I recently read in an organ builder's web site that at the most he would only recommend a tuning visit to an organ every two or three years. It is hard to believe this and I can only think he must have some remarkable organs on his books, all of which must be in tip top condition. Possibly on very small jobs you could get away with it, but on large, comprehensive instruments this would not be acceptable (to many ears). Perhaps my customers and I expect perfection. Very few of the large number of organs in my care would be ok with just the reeds "touching up' on a visit even though many people may not notice. I have sometimes gone to organ recitals where the fluework is adrift and I find myself concentrating on this and not able to enjoy the music. For this reason I seldom go to recitals anymore.
  10. At the risk of showing my ignorance, I should like to know what "Willis" bearings are - I presume they are some form of 'unequal' temperament. With regard to CYNIC'S preference for hardly ever touching the fluework and his delight in having beating ranks between departments in imitation of an orchestra I must say he must be an easy customer to please. I always check the bearings and the tuning between departments on each visit and "correct" any erring pipework. Perhaps I have been wasting my time and the customers money for over the past thirty eight years? I hope not. I have always taken the view that the job of tuner on a visit (after sorting out problems) is to go through all the pipework and ensure it is as 'in tune' as possible. Obviously on some jobs much more attention is required due to temperature, humidity, dirt, general condition of soundboards and a host of other factors.
  11. To get back to the subject of tuning, the matter of wind loss between sliders, upperboard and table hasn't been mentioned. With badly fitting sliders, when the humidity changes there is slightly more or less wind loss which can (in my humble experience)result in 'out of tuneness' as the pipes receive a different amount of wind. In some instruments (old ones) where we have fitted slider seals or retrued sliders and table, the tuning stability has improved vastly. The combination of well fitting sliders, cone tuning and a stable temperature and humidity is the ideal. Also, a spotlessly clean environment. (!!!) without insects. Regarding the damage caused by cone tuning. On several newish jobs we I look after (under 30 years old) where the pipework has a high tin content I have noticed that due to heavy 'bashing' with the cone (not my doing!) some of the pipes have started to crease at the mouth. Although such heavy coning should never have happened I wonder if the metal is too thick around the top of the pipe. Strangely, I look after quite a number of old and historic instruments with coned tuned pipes, many of which are in lovely condition, partly due, I think to minimum and careful tuning over the years. It always pains me to see bashed and carelessly tuned pipes. Having said that, 'pinched' ones at least are usually ok at the mouth and foot and can usually be straightened out quite easily.
  12. I am also looking for an organ to replace a feeble and inadequate (though 'historic") instrument in this area. I have been checking the IBO redundant list and George Sixsmith's for the past year and cannot find anything suitable. In this case the requirements are a largish 2 manual of around eleven sp. stops on each with tracker (manual) action. It must be a decent quality instrument in fair condition. I did contact a redundant church in Bolton with the ideal organ (by Isaac Abbott), but they wish to leave in in situ. I shouldn't have thought that finding such an instrument would be too difficult, but it seems that those already listed for disposal are either too small, or nondescript largish jobs, usually with tp action. If anyone can help I should love to hear from you. I don't think my request will be in conflict with Hector's as his requirements are obviously for a much more comprehensive instrument.
  13. I was about to mention St. Agnes myself, being based in the Northwest myself, I can recommend their lots of good photos. The organ case on it's gallery look very striking, I presume they were both designed by JLP. Looking at the details of the R&D organ on the NPOR it doesn't look like it was particularly distinguished but it's still a shame that it is now silent. Rather a sweeping statement. I don't know whether or not you have come across Wordsworth & Maskell organs of this period, but they are, without exception, of great tonal quality - equal to Hill of this period. I can't speak for the Rushworth & Dreaper alterations. Hopefully, they didn't add too much tonally!
×
×
  • Create New...